Aquí hi podem sentir gravacions mp3 d’alguns modes digitals més utilitzats pels radioaficionats.
- AMTOR (Amateur Teleprinting Over Radio)
- BPSK125 (Phase Shift Keying)
- CONTESTIA 16-500
- CW (Continuous Wave o Telegrafia)
- MFSK16 (Multiple Frequency Shift Keying)
- OLIVIA 32-1000
- PACKET 1200 Bauds
- PACKET 300 Bauds
- RTTY 75 Bauds
- RTTY (RadioTeleType)
- RTTYM 8-250
- SSTV (Slow Scan Television)
PSK31 or “Phase Shift Keying, 31 Baud” is a popular computer soundcard generated radioteletype mode, used primarily by amateur radio operators to conduct real time keyboard-to-keyboard chat, most often using frequencies in the high frequency amateur radio bands (shortwave). PSK31 is distinguished from other digital modes in that it is specifically tuned to have a data rate close to typing speed, and has an extremely narrow bandwidth, allowing many conversations in the same bandwidth as a single voice channel. This narrow bandwidth also concentrates the RF energy in a very narrow bandwidth, allowing relatively low-power equipment (25 watts) to communicate globally using the same skywave propagation used by shortwave radio stations.PSK31 was developed and named by English amateur radio operator Peter Martinez (call sign G3PLX) and introduced to the wider amateur radio community in December 1998.
The 31 baud BPSK modulation system used in PSK31 was introduced by Pawel Jalocha (SP9VRC) in his SLOWBPSK program written for Motorola’s EVM radio. Instead of the traditional frequency-shift keying, the information is transmitted by patterns of polarity-reversals (sometimes called 180-degree phase shifts). PSK31 was enthusiastically received, and its usage grew like wildfire worldwide, lending a new popularity and tone to the on-air conduct of digital communications. Due to the efficiency of the mode, it became, and still remains, especially popular with operators whose circumstances do not permit the erection of large antenna systems, the use of high power, or both.
Radioteletype (RTTY) is a telecommunications system consisting originally of two or more electromechanical teleprinters in different locations connected by radio rather than a wired link. These machines were later superseded by personal computers (PC) running software to emulate teleprinters. Radioteletype evolved from earlier landline teleprinter operations that began in the middle1800. The US Navy Department successfully tested printing telegraphy between an airplane and ground radio station in 1922. Later that year, the Radio Corporation of America successfully tested printing telegraphy via their Chatham, Massachusetts, radio station to the R.M.S. Majestic. Commercial RTTY systems were in active service between San Francisco and Honolulu as early as April 1932 and between San Francisco and New York City by 1934. The US military used radioteletype in the 1930 and expanded this usage during World War II. From the 1980s, teleprinters were replaced by computers running teleprinter emulation software.
The term radioteletype is used to describe both the original radioteletype system, sometimes described as “Baudot”, as well as the entire family of systems connecting two or more teleprinters or PC using software to emulate teleprinters, over radio, regardless of alphabet, link system or modulation. In some applications, notably military and government, radioteletype is known by the acronym RATT (Radio Automatic Teletype).
JT65, developed and released in late 2003, is intended for extremely weak but slowly varying signals, such as those found on troposcatter or Earth-Moon-Earth (EME, or “moonbounce”) paths. It can decode signals many decibels below the noise floor in a 2500 Hz band (note that SNR in a 2500 Hz. band is approximately 28 dB lower than SNR in a 4 Hz band, which is closer to the channel bandwidth of an individual JT65 tone), and can often allow amateurs to successfully exchange contact information without signals being audible to the human ear. Like the other modes, multiple-frequency shift keying is employed; unlike the other modes, messages are transmitted as atomic units after being compressed and then encoded with a process known as forward error correction (or “FEC”). The FEC adds redundancy to the data, such that all of a message may be successfully recovered even if some bits are not received by the receiver. (The particular code used for JT65 is Reed-Solomon.) Because of this FEC process, messages are either decoded correctly or not decoded at all, with very high probability. After messages are encoded, they are transmitted using MFSK with 65 tones.
Operators have also begun using the JT65 mode for contacts on the HF bands, often using QRP (very low transmit power); while the mode was not originally intended for such use, its popularity has resulted in several new features being added to JT65-HF-HB9HQX in order to facilitate HF operation.
Hellschreiber (HELL) or Feldhellschreiber (also Hell-Schreiber named after its inventor Rudolf Hell) is a facsimile-based teleprinter invented by Rudolf Hell. Compared to contemporary teleprinters that were based on typewriter systems and were mechanically complex and expensive, the Hellschreiber was much simpler and more robust, with only two moving parts. It has the added advantage of being capable of providing intelligible communication even over very poor quality radio or cable links, where voice or other teledata would be unintelligible.
The device was first developed in the late 1920, and saw use starting in the 1930, chiefly being used for land-line press services. During WW2 it was sometimes used by the German military in conjunction with the Enigma encryption system. In the post-war era, it became increasingly common among newswire services, and was used in this role well into the 1980. In modern times Hellschreiber is used as a communication mode by amateur radio operators using computers and sound cards; the resulting mode is referred to as Hellschreiber, Feld-Hell, or simply Hell.